Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual do Utilizador Página 81

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 124
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 80
User module »DVI-CON-2«
Target and user modules · 77
Status displays
Front panel
The LEDs on the front panel of the user module show the system’s operating status.
Section LED Status Meaning
Power Red. On The optional power pack is connected and the required voltage
(12
Volt) is available.
Off The optional power pack is not (properly) connected.
Main On The main power supply provides the required voltage.
Off The power button is turned off or the connection with the mains
could not be established.
Check the proper connection of the power supply cable.
Status Trans. On The communication with the connected matrix switch or the tar-
get module of the active channel could be established success-
fully.
Off The communication with a matrix switch or target module of the
active channel could not be established.
System On The device is booting or carries out a firmware update.
Blinking The system is ready for operation.
Console Video On Stable image signal at video input.
Off The incoming video signal could not be detected or it lacks the
required quality to be processed by the system.
K/M On A local keyboard was found.
Off No power at PS/2 interface or USB bus.
Blinking The CPU input (PS/2 or USB) is active and ready.
No local keyboard was found.
Trans. Active On Active channel.
Off Inactive channel.
Status On The communication with the connected matrix switch or the tar-
get module of this channel was established successfully.
Off The communication with a matrix switch or target module of this
active channel could not be established.
Trans.
System
Main
Red.
Video
K/M
Status
Power
Service
Console
Status
Active
Trans. 1
Trans. 2
Vista de página 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 123 124

Comentários a estes Manuais

Sem comentários